How To Stretch Chain Link Fence Tension Wire

Replace Fence Ties On Bottom Of Line Posts.

Pull the tension wire taut by hand along the fence line. Tightening up a saggy chain link fence requires special tools and speed a little effort. Ordering one extra tension bar per fence job as it is convenient to use one to stretch with using either a pull chain, or chain link stretch bar.use 5/8 wide bars for residential applications and 3/4 wide bars for commercial applications.

If Installing Top Tension Wire, You Will Thread The Wire Through The Loop Caps.

Replace fence ties on bottom of line posts. At every line post, tie the tension wire to the line post with a fence tie. Common wire used as a bottom tension wire on a chain link fence is 9 gauge galvanized wire.

This Is Not Always Noticeable When Stretching.

Super easy, make a tightening tool utilizing a piece of scrap pipe i used 1 1/4 pipe with a 1/4 hole drilled 1 1/2 from the end , and then drilled out a 5. Cut your tension wire and attach to the end band located at the base of the terminal post. Easy as cake, go to the store and pick up 5.00 worth of parts and you will be a chain link master installer in no time at all, but be careful, all of your fr.

At Every Line Post, Tie The Tension Wire To The Line Post With A Fence Tie.

This sagging is usually because of by repeated climbing over. With your pliers, bend a one foot section of tension wire around the nut and bolt located in the end band. Ordering one extra tension bar per fence job as it is convenient to use one to stretch with using either a pull chain, or chain link stretch bar.

If Installing Top Tension Wire, You Will Thread The Wire Through The Loop Caps.

Install tension wire at the bottom of your fence. Use 5/8 wide bars for residential applications and 3/4 wide bars for commercial applications. Place your wire dog approximately ten feet from the terminal post.